Pressure Washer Surface Cleaners
Starting An Electric Pressure Washer
Starting A Gas Pressure Washer
Clean Siding With A Pressure Washer
Pressure Washer Detergents
Pressure Washer Extension Wands
Pressure Washer Nozzles
Pressure Washer Safety
Pressure Washing Wooden Decks
Pressure Washer Pump Repair
Stripping Paint
Starting an Electric Air Compressor
Starting a Gas Air Compressor
Using 70,000 BTU Heaters
Using 190,000 BTU Heaters
Using the 190,000 BTU Kerosene Forced Air Portable Heater
Cold weather can't keep you from getting work done when you have a kerosene portable heater to warm up your work area.
This video will show the proper startup, operation, and shut down procedure for this Mi-T-M 190,000 BTU portable heater.
While outside or in a well ventilated area, on a level surface, fill the tank with fresh, #1 kerosene or # 1 or # 2 diesel fuel until the gauge points to F.
Replace the cap securely, and move the heater into your workspace. Ventilation is very important, and fresh air must be provided in your workspace.
Plug the power cord into a 3-prong, grounded extension cord, which is plugged into a GFCI grounded outlet or a generator.
Turn the thermostat control knob to the desired temperature setting. The setting range is from 40° F to 110° F.
Press the Power switch to the "ON" position.
The power indicator lamp and room temperature display will light, and the heater will start.
If the thermostat is set too low, the heater will not fire. Simply turn up the thermostat until the heater fires.
Never leave the heater unattended while it is burning, or connected to a power source.
When you are finished using the heater, or need to leave the area, press the Power switch to OFF, and unplug the power cord.
If you need to restart the Mi-T-M heater, plug the power cord back in, and wait at least 10 seconds before pressing the Power Switch to ON again.
