Mi-T-M hot water pressure washer trailers are perfect for on-site cleaning of dirt and grime. The single-axle trailer is compact, powerful, and equipped with a 3500 PSI hot water pressure washer. It also includes a 200 gallon water tank and hose reel that can hold up to 150 feet of hose. The below video and guide will help you learn how to use this trailer.

Before Using → What To Know

1. First, determine what needs to be cleaned and where it’s located.
2. Next, decide if there are any cleaning accessories that could be used to make the job easier such as a surface cleaner.

Setting Up → Preparing To Use

1. Easily hook up this trailer with the adjustable trailer coupler hitch.
2. Attach the safety pin chains and connectors and then tow the trailer to the job site and park it on a flat surface.
3. Remember to always wear eye and ear protection along with closed-toe shoes when operating the equipment. Reading the owner's manual beforehand is also recommended.
4. Make sure there is water in the tank and the battery cables are secured.
5. Check to be sure there is sufficient fuel.
6. Unwind the hose from the hose reel and connect the dual lance with the preferred nozzle to the hose.

Starting The Unit

1. Point the lance in a safe direction, squeeze the trigger, and start the pressure washer by pulling out the choke and turning the key to the “on” position.
2. Once the unit starts, push in the choke.
3. Use the unit for cold water cleaning, or turn the burner on to clean with hot water.
4. Always point the lance in a safe direction while using a continuous motion to clean.

Use Cases

1. The trailer is ideal for removing dirt, grime, oil, and grease.
2. It can be used in a variety of industries including municipalities, agriculture, construction, oil & gas, and more.

Compliment Your Equipment → Accessories

1. A rotary surface cleaner can be used to clean large surfaces in a fraction of the time.
2. A rotating nozzle uses a powerful rotating spray for extra cleaning power.

Shutting Down The Unit

1. To shut down the pressure washer, first turn the burner off.
2. Squeeze the trigger to relieve the pressure and discharge the water for at least 3 minutes to allow the equipment to cool.
3. Be careful not to touch the lance until it has cooled down.
4. Turn the key to the “off” position.
5. Disconnect and drain the hose and lance.

Need Help?

Contact Mi-T-M or find a dealer today to learn more ways we can help you and your business.